wanted.. driver side stock headlight

612 Views 3 Replies 2 Participants Last post by UndefinedTaco, Feb 27, 2010

pdsrunner

Discussion Starter · Feb 26, 2010

i got a 2001 s-runner.. and some f*cker hit my passenger side front and i had my insurance fix it. but they only replaced one headlight. so i got one new looking passenger headlight and a old driver side headlight with dust in it.. does any one have a clean new looking driver side stock headlight or tips on how to clean the inside of the housing..

Save

1 - 4 of 4 Posts

UndefinedTaco

· #2 · Feb 27, 2010

pop it in your oven for 12 minutes on like 270 degrees..

will heat up the silicone and pop it right off.

clean it

then either re heat it and get it to stick again to headlight
then take it out and let it dry..

or re silicone it.

See less See more

Save

pdsrunner

Discussion Starter · #3 · Feb 27, 2010

UndefinedTaco said:
pop it in your oven for 12 minutes on like 270 degrees..

will heat up the silicone and pop it right off.

clean it

then either re heat it and get it to stick again to headlight
then take it out and let it dry..

or re silicone it.

yea i think ima try to open it and clean it and see i can get it to look as clean as the other one.. thanks for the tip bro.. ima try it in a couple of days..

Save

UndefinedTaco

· #4 · Feb 27, 2010

hit it with some clear x
you can buy the kit or just the bottle from walmart

like 5 bucks for bottle maybe, 10 for kit..

then hand buff the foggyness on outside..or use the kit(gives you a brush for your drill).

then clean inside..and do the same.

and it will bring it back to normal.:waytogo:

See less See more

Save

1 - 4 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month