Toyota Tacoma Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
478 Posts
Discussion Starter #1
I have no headlights or taillights. The wiring harness burnt before, and I had to replace it. Now the new one is burnt, no clue as to why. I have tried to wire the headlights direct, but can't get them to come on. The park lights, turn signals, and backup lights work fine. So, I'm wanting to run the headlights and taillights on switches. I have two factory fog light switches, that I am not using, and wanted to use one for each. Any and ALL help is GREATLY appreciated!!!!!
 

·
Mambeau / Admin
Joined
·
47,863 Posts
As near as I can tell from the FSM Wiring Manual, the only two things your head- and taillights have in common are connections to the Body ECU and to the 'combination switch' (light controls on the column).

Seems to me the only kind of fault that would burn both circuits simultaneously (and nothing else, right?) would have to be located at either of these points or 'upstream'....

Do you have DRL or any lighting mods wired into your light circuits?

:thinking:
 

·
Registered
Joined
·
478 Posts
Discussion Starter #4
Nothing wired into it. Like I said, the connector that plugs into the light "stalk" is what smoked and burnt.
 
1 - 4 of 4 Posts
Top