Toyota Tacoma Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
411 Posts
Discussion Starter · #1 ·
Ok. What if I used this: http://www.jegs.com/webapp/wcs/stores/servlet/CategoryDisplay?storeId=10001&catalogId=10002&catalogIdentifier=Jegs_Direct&categoryId=13983&parentCategoryId=10265

and attached this: http://store.summitracing.com/partdetail.asp?autofilter=1∂=QTP%2DQTEC25&N=700+115&autoview=sku

to where the plate goes... Would I see a pretty decent increase in power by turning it on and off? I guess mainly i'm lookin for sound, though.

The stock exhaust is all stainless steel, right? and 2 1/2 in, so why would I want to get rid of it???
 

·
Registered
Joined
·
14,485 Posts
you wont notice much power at all if any unless your turbod or mabey even s/c'd... as for sound just get a weld in muffler in place of the stocker.. and the stock exhaust is not stainless steel.. and i believe its 2.5 inches.. howeveri believe the older tacos exhaust was 2 1/4



 

·
Vendor
Joined
·
7,124 Posts
If you just use a straight pass through muffler like a Borla or Magnaflow, then you end up with the same thing without all the complication.

Don't try to over engineer a simple thing.

Cutouts are handy on modern trucks if you can get them in front of the cats.

Gadget
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top