Toyota Tacoma Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
116 Posts
Re: DJMs 3/4 Drop Kit -Where your overload springs

though I didn't install the DJM kit, I did pull the overload leafs off, and I installed 1" blocks on my '01 S-Runner. Now it sits level, and no problems other than more axle wrap when I get on it. I'll be making some traction bars to help eliminate the axle wrap next. If you plan on hauling a large payload, keep the overload leafs, and see if flipping them over gives more clearance; mine were installed "arc down" from Toyota. Flipping them may give you another inch clearance, but may make the ride stiffer too.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top