Toyota Tacoma Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
173 Posts
Discussion Starter · #1 ·
I have a dent that goes through the door , cab corner , and the bed on the bottom body line. It isn't a solid streak , but skips every few inches. On the bed , it looks like the dent moved the panel in a little bit and the transition between the cab and bed isn't straight , or is it like this from the factory. I tried to look on the driver side to see it was the same , but i can't tell. You can stand back and see the panel is off. If i took the dent out with a hammer and dolly , will the panel pop back out , to match the cab. The top part of the panel on bed matches the cab until about half way down were it starts to move in.

Thanks For the help,
Dirk
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top