Toyota Tacoma Forum banner
1 - 7 of 7 Posts

·
Premium Member
Joined
·
11,863 Posts
buy the headlight with just a clear lens to start.then a projector, then ballasts and bulbs . then make a wiring harness, bolt the projector to the headlight after you take the lens off go check if the rotational direction is correct. then tighten everything reall tight and use thread lock. then make it look pretty, then put the lens back on. put them on your truck adjust your hight so the lower step is down about 2inch at 25 ft. amake sure the driver side projector is stright and the right side is curve towrd the left. and your done.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top