Toyota Tacoma Forum banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
4,441 Posts
hehehe..funny that you should mention "put them in correctly"..

Yeh, I installed mine upside-down and didn't realize it until we pulled the bed off to notch the frame. Whoops! They're still ok, though, amazingly.
 

·
Premium Member
Joined
·
4,441 Posts
Normally, the new frame peices are welded solid to the existing frame in the correct location. Then, the actual frame is cut-away from "under" the new frame section. Take a look in the tech section at the photo gallery of installing a 6" step notch. This is how mine was done.

Hope this helps.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top