Toyota Tacoma Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Anyone run .060 pistons? Plenty of meat on the thrust and non thrust sides of the cylinders. Anyone know if these have a tendency to run warm with with .060 over? The block in question has bores that are past .040 now and if .060 runs good in this engine I rather get a set of pistons made than go through the work of sleeving. Thanks
 

·
Registered
Joined
·
3,761 Posts
Call up LCE and ask the question, they know for sure. I ended up going .040 over on my engine a couple of years back and had a concern if I was able to go any further once I did that (if need be). I don't remember who I spoke to but he assured me that they routinely go past that and haven't had any real problems.
 
  • Like
Reactions: Jordan988
1 - 2 of 2 Posts
Top