2rz/3rz Aluminum intake manifold - Page 3

rtetaco · 12-23-2012, 06:31 PM

This intake I have here will be a nice experiment to see what if anypower it can flow!

Pics speak for themselves

Quote:

Originally Posted by 671taco

Yea, just to clarify a couple things. Gabe is now utilizing machined flanges now for better hp results. The first couple manifolds including the one that I'm selling he used the stock flange from the manifold. On the dyno sheet where I made 415hp that is the intake without porting yet. So the intake still flows well.

All you need to do is port your intake flange to match the gasket and you should be good bro! I wouldn't chuck the intake....What's ur setup?

Now the manifolds will be a little more expensive due to the machined flanges.

SlAMMEdtAC0 · 12-25-2012, 10:19 PM

Quote:

Originally Posted by rtetaco

This intake I have here will be a nice experiment to see what if anypower it can flow!

Pics speak for themselves

I think that one will give you decent power. If the runners were just slightly smoother it looks like it would flow nicer. But I think you'll get more power then the ugly stock one

671taco · 12-26-2012, 04:15 AM

Quote:

Originally Posted by SlAMMEdtAC0

I think that one will give you decent power. If the runners were just slightly smoother it looks like it would flow nicer. But I think you'll get more power then the ugly stock one

It will and flows better than stock... just fyi my buddy did ask to redo it with cnc flanges or if he wanted a refund. So no hard feelings...

rtetaco · 12-26-2012, 09:11 AM

671taco I apologize for muddying up your for sale thread. I will start my own thread at some point and comment/complain there.

looking forward to seeing what your plans are next on your 400+ horse rz.

671taco · 12-29-2012, 11:28 AM

Quote:

Originally Posted by rtetaco

671taco I apologize for muddying up your for sale thread. I will start my own thread at some point and comment/complain there.

looking forward to seeing what your plans are next on your 400+ horse rz.

No worries...just know that the intake flows way more than stock and will not hinder performance under forced induction.

500hp is on the way!

By the way this manifold is SOLD!!! CLOSE THREAD!!!!