Join Date: Jul 2009
Location: shrewsbury, MA
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
||Thread Tools||Display Modes|
all the holes are there and threaded, only thing on the tacomas that are equiped with factory buckets the rear inside hole is on the tranny hump, my truck does not have that hole, so i used the seat belt hole on the floor and it was perfect, and i think im sitting about the same in height.
This is due to having a single cab with a factory bench I believe. If you had an XCab with 60/40 seats it would have the hole on the hump. I like your setup. My only suggestion is that you weld a support on the rear outboard bracket. Otherwise, it may eventually bend under your weight and cause the seat to lean outward.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Transplanting '91 bucket seats for '99 bench seats||militaco||Interior/Audio/Electronics||6||12-04-2008 06:46 PM|
|Trade Bench Seats for bucket seats||YankeeTaco72||Wanted||7||07-22-2008 12:17 AM|
|Ltd Bucket Seats/S-Runner Seats, Tan/Oak||MountainBiker||Wanted||18||12-09-2005 10:16 AM|
|Bucket seats||Cajuntaco||Off Road||7||02-12-2003 02:57 PM|
|bucket / bench seats...need info on corbeau seats||va burnt taco||Performance||3||10-31-2002 07:01 PM|