Only clean your MAF sensor when you SEE with your eyes that it is indeed dirty. There's no other reason to clean it. Don't clean it because you have a CEL and you figure that will fix the problem.
If you do see it is dirty and need to clean it, then use an electronics cleaner that has the following properties; leaves no residue and is safe for plastics. Make sure it is safe for ABS plastics. Many of the better electronics cleaners will crack ABS plastic. This is the plastic your MAF sensor, and the housing on the V6's is made from.
If your air flow sensor is dirty in most cases you will get a P0171 MIL. this code is for "system too lean Bank..." The system is indeed lean because the dirt or K&N oil that builds up on the air flow sensor is stopping the air from flowing across the hot wire.
If the air is not touching the hotwire then the ECU doesn't know it is entering the engine. The ECU is basing how much fuel is required on the throttle position, the MAF sensor voltage, and also from other feedback sensors such as the O2 sensors.
If any of that info from the sensors is bogus, (such as a contaminated hotwire) the ECU will see it and after it has operated out of it's programmed specifications you will get a Check engine light.
When it first happens you will have a diagnostic code that is pending and can only be seen with a scanner.
Feel free to add your $.02
If you do see it is dirty and need to clean it, then use an electronics cleaner that has the following properties; leaves no residue and is safe for plastics. Make sure it is safe for ABS plastics. Many of the better electronics cleaners will crack ABS plastic. This is the plastic your MAF sensor, and the housing on the V6's is made from.
If your air flow sensor is dirty in most cases you will get a P0171 MIL. this code is for "system too lean Bank..." The system is indeed lean because the dirt or K&N oil that builds up on the air flow sensor is stopping the air from flowing across the hot wire.
If the air is not touching the hotwire then the ECU doesn't know it is entering the engine. The ECU is basing how much fuel is required on the throttle position, the MAF sensor voltage, and also from other feedback sensors such as the O2 sensors.
If any of that info from the sensors is bogus, (such as a contaminated hotwire) the ECU will see it and after it has operated out of it's programmed specifications you will get a Check engine light.
When it first happens you will have a diagnostic code that is pending and can only be seen with a scanner.
Feel free to add your $.02