Toyota Tacoma Forum banner

DIYPNP MS EFI setup for 2rz

2K views 3 replies 2 participants last post by  hamish_18 
#1 ·
I am attaching information I put together on the DIYPNP setup for a 1999 2rz running wasted spark. I will attach more information on assembly of the board. I had Chris (hamish_18) do my assembly but hope to help those in the future. Chris, chime in if you like!



Enjoy
 
See less See more
1
#3 ·
I just need to figure out my tach situation. I have my aftermarket tach wired to the tach out pin on the megasquirt. It reads about 1/2 of what the actual RPMs are and it cuts down to 0 when the truck starts making boost. Very odd.

Also need to figure out how to wire up the circuit for Launch control.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top